Advanced Technologies and Materials

Lorem ipsum dolor sit amet, consectetur adipisicing elit, sed do eiusmod tempor incididunt ut ero labore et dolore magna aliqua. Ut enim ad minim veniam, quis nostrud exercitation ullamco.

Search
GUIDE FOR AUTHORS SUBMIT MANUSCRIPT
Vol. 38 No. 1 (2013): Journal for Technology of Plasticity
Original articles

Transfersal upsetting of steel wire

Full text article (PDF)
  • Brane Tola,
  • Janez Kramar,
  • Karl Kuzman
Brane Tola
Faculty of Mechanical Engineering, University of Ljubljana, Aškerčeva 6, 1000 Ljubljana, Slovenia
Janez Kramar
Faculty of Mechanical Engineering, University of Ljubljana, Aškerčeva 6, 1000 Ljubljana, Slovenia
Karl Kuzman
Faculty of Mechanical Engineering, University of Ljubljana, Aškerčeva 6, 1000 Ljubljana, Slovenia

Published 2013-06-28

abstract views: 7 // Full text article (PDF): 3


Keywords

  • Upsetting,
  • FEM,
  • Wire

How to Cite

Tola, B., Kramar, J., & Kuzman, K. (2013). Transfersal upsetting of steel wire. Advanced Technologies and Materials, 38(1), 57–73. Retrieved from https://atm-journal.uns.ac.rs/index.php/atm/article/view/JTP.2013.38.1.6
Creative Commons License

This work is licensed under a Creative Commons Attribution 4.0 International License.

Abstract

The results of stress and forming load analyses for transversal upsetting process of cylindrical specimens are presented. The analyses were performed for practical reasons in order to get adequate information for the balancing of progressive die for the forming of steel wire. Special attention has been paid to the process of transversal upsetting by flat dies for cylindrical specimens with the diameter between Ø3 mm and Ø6 mm. The results were obtained with the FEM simulations and experiment. The presented approximate equation for forming load and diagrams with the geometrical characteristics are used within the presented limits of diameters of cylindrical specimens.

PlumX Metrics

Dimensions Citation Metrics

Full text article (PDF)