Advanced Technologies and Materials

Lorem ipsum dolor sit amet, consectetur adipisicing elit, sed do eiusmod tempor incididunt ut ero labore et dolore magna aliqua. Ut enim ad minim veniam, quis nostrud exercitation ullamco.

Search
GUIDE FOR AUTHORS SUBMIT MANUSCRIPT
Vol. 42 No. 1 (2017): Journal for Technology of Plasticity
Original articles

Determination of forces at the transverse extrusion

Full text article (PDF)
  • A. K. Belan,
  • V. A. Nekit,
  • S. I. Platov,
  • N. N. Ogarkov,
  • O.A. Belan
A. K. Belan
Nosov Magnitogorsk State Technical University, Lenin Street, 38, Magnitogorsk city, Chelyabinsk Region, Russian Federation, 455000
V. A. Nekit
Nosov Magnitogorsk State Technical University, Lenin Street, 38, Magnitogorsk city, Chelyabinsk Region, Russian Federation, 455000
S. I. Platov
Nosov Magnitogorsk State Technical University, Lenin Street, 38, Magnitogorsk city, Chelyabinsk Region, Russian Federation, 455000
N. N. Ogarkov
Nosov Magnitogorsk State Technical University, Lenin Street, 38, Magnitogorsk city, Chelyabinsk Region, Russian Federation, 455000
O.A. Belan
Nosov Magnitogorsk State Technical University, Lenin Street, 38, Magnitogorsk city, Chelyabinsk Region, Russian Federation, 455000
DOI: https://doi.org/10.24867/jtp.2017.42-1.9-19

Published 2017-06-30

abstract views: 12 // Full text article (PDF): 0


Keywords

  • cold bulk stamping,
  • upsetting,
  • transverse extrusion,
  • method of work balance

How to Cite

Belan, A. K., Nekit, V. A., Platov, S. I., Ogarkov, N. N., & Belan, O. (2017). Determination of forces at the transverse extrusion. Advanced Technologies and Materials, 42(1), 9–19. https://doi.org/10.24867/jtp.2017.42-1.9-19
Creative Commons License

This work is licensed under a Creative Commons Attribution 4.0 International License.

Abstract

In the process of cold bulk stamping tools are exposed to high stresses. While developing technology and tool design one should provide the longitudinal stability of the workpiece and the high durability of the tool. For this reason it is necessary to determine the loads which occur during process. The paper presents a method for determination of the force for the transverse extruding, which was based on the method of the works balance. Experimental studies have been performed, which showed that the developed method allows with sufficient accuracy to calculate the total load at the die for the transverse extruding.

PlumX Metrics

Dimensions Citation Metrics

Full text article (PDF)